Chances are if your TV does not turn on or power on, then most likely the fuse blown on the board inside the TV, easy fix, just replace the fuse. The fuse can be purchase online ebay amazon etc. really cheap so no need to throw it away π
Some of these Vietnamese herbs can be grown in low light inside the house with a little bit of creativity, by covering it with plastic keeping moisture in and water it daily let it breath by removing it to water then put it back and wallahhh!!!
Yes cost me $2 to make this, basically wood is free, LED cost $1, USB DC inverter 5v-12v $1, and the usb charger plug is free a bunch lying around the house got it for free from people threw them away π
Yes I did the brake fluid self bleed using gravity π there were lots of small bubbles but seems to be ok, no the big bubbles though, big bubbles would not be ok.
I tied liquid wrench for 1 hour about 15 repeat then hit with an impact wrench no go. Then I tried heating it up with the torque and hit it with impact wrench, still no go. I took a look at it closer, look like not just the screw thread got siege but the pin also appear to have been stuck as well. The cause might have been because overheating causing it to melt and self soldered. In the head I purchase a new complete set of caliper for $60 on ebay, who cares it’s china made, just have to review test it properly before installing and test it again π and it will not last long so keep that in mind.
Here is the result π Walmart black beans as bean sprout. The result show 50% sprout, but long I have to cut the head beans because it’s big, however the taste is as good or better than mung beans. Just that the machine I use withe the cycling over and over again making it reddish.
Easy, with warm to hot water from the sink π now it was an emergency for me after getting an error message displaying asking me to contact service error code “SC 28113”. After google search for fix, 90% said to replace the ink cartridge then turn on the printer and let it run it normal power up mode. For my case that didn’t work, however I do see the message saying my K black ink cartridge is low, after looking at it and fill it up, I noticed the nozzle appear to have been clogged because the cartridge is filled up full but the ink not going to nozzle. So to me it appears to have been dried so what to do? well from knowledge warm water or hot water will undried it, well it work, let it soak in warm to hot water for like 5-10mins and then shake it a little bit and wallah I see the ink now moving to the nozzle. π
Been driving with a really loud sound coming from the wheel bearing I think. It started with some click noise like hitting a gap or uneven surface on the road, but then it started to making humming sound, then got louder and louder now sound like a motorcycle muffler. This had happened before, but not exactly. Purchased from ebay got the brake rotors pads, and wheel bearing front, all for $160, don’t need anything fancy or expensive since this is an old 2005 nissan quest.
Borrowed a pressure wash since the one I got is electric and it’s not as strong and doesn’t appear to be working either. So this one I borrowed is powerful with a Honda gasoline engine.
